Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specific
equipment and special equipment for this
model series. Thus, some equipment or
features described in this manual may not
be installed onto your vehicle or are only
available in some markets. For the further
configuration information, please refer to
relevant sales information or consult with
your distributor selling the vehicle to you.
Starting vehicle
Normal startup
1. Make sure to carry the smart key with
you.
2. Adjust seat position and take correct
driving gesture.
3. Confirm that the parking brake has
been applied.
4. Make sure the P gear is engaged.
5. Step on the brake pedal.
6. Press the ignition switch to start the ve-
hicle. (At this time, the indicator
in the combination instrument being on
indicates that the drive system is
ready.)
Notice
After the vehicle is started, the engine will
be started or stopped automatically ac-
cording to the vehicle state.
Emergency startup
D6A8053406FC
If the vehicle prompts "check if the key is
in the vehicle" (for example: the intelligent
key loses power; the door guard plate or
the rear bumper is severely damaged,
etc.), open the front armrest storage case
and put the intelligent key above the mark
in the storage case to perform the nor-
mal starting operation of the vehicle. Then
the vehicle can be started. If the vehicle
still cannot be started, please contact the
service provider immediately.
Warning
〉
Be sure to sit on the driver's seat before
starting the vehicle. Failure to do so may
lead to accident, serious injury or even
death.
〉
Do not step on the accelerator pedal un-
der any circumstances when starting the
vehicle.
〉
Always start the vehicle even if you need
to move the vehicle slightly. Failure to do
so may result in an accident.
Starting and shutting off vehicle
93
2
Driving
To Next Page
Loading...
