〉
The current vehicle is driving too close to the preceding vehicle to prevent the camera
from detecting it.
〉
The rear vehicle is driving too close to the current vehicle to prevent the sensor from
detecting it.
Smart dodge function
After the smart doge function is turned on, if the lane assist or intelligent cruise is turned
on and in working condition, when the system identifies that the vehicle is about to over-
take the adjacent large vehicles (wagon, truck, bus, etc.), it will control the vehicle to
move slightly away from the large vehicle. After overtaking the large vehicle, your vehicle
will return to the central area of the current lane.
Notice
The smart doge function will not begin to work until the vehicle speed reaches 60 - 140
km/h.
Caution
The following situations may not trigger the smart dodge function:
〉
When the system identifies that there is a large vehicle on the adjacent road on one
side, and there are vehicles on the adjacent road on the other side or the road is a
curb.
〉
In severe weather such as night, heavy fog, rain and snow.
〉
When the vehicle is in a curve.
Warning mode
There are three warning modes: sound, vibration, and sound + vibration.
Warning sensitivity
Sensitivity is divided into three levels: low, standard and high.
Rear side assist system
The rear side assist system can detect vehicles behind the vehicle or in the adjacent lane
through sensors on both sides of the rear bumper. If there is a risk of collision, the system
will issue an alarm to remind the driver to drive safely.
136
2
Driving
To Next Page
Loading...
