〉
Please turn off the low-speed emergency braking function after the vehicle is equipped
with traction devices or when the vehicle is towing other vehicles. Otherwise, the sys-
tem may apply unnecessary braking.
〉
【Flank protection】
You can enable or disable the flank protection function.
After the function is enabled and when the sensors on the left and right sides of the ve-
hicle body identify obstacles, the system prompts the driver to park carefully through
pictures and sound alarms.
〉
【Automatic steering ON】
You can enable or disable the automatic steering function.
After the function is activated, set to D gear and turn on the turn signal lamp or turn the
steering wheel to a certain angle, then the AVM will be automatically turned on. After
the steering wheel is restored, the AVM will be automatically turned off when the turn
signal lamp is off or the vehicle speed exceeds a certain value, .
〉
【AVM exit speed】
You can set the AVM exit speed.
The AVM will be turned off automatically when the vehicle speed exceeds a certain val-
ue.
〉
【Road calibration】
During the using of vehicle, when the camera position changes due to bumping of vehi-
cles or aging of parts , the image mosaic may be misplaced, blurred and distorted. At
this time, the image mosaic effect can be optimized through the road calibration setting.
Please refer to the prompt information on the multimedia display screen for the specific
calibration methods and requirements.
〉
【Reset factory calibration】
After re-calibrating the road, you can restore the factory calibration by pressing the “re-
store factory setting”.
〉
【AVM ON】
You can enable the AVM by touching the AVM ON button.
120
2
Driving
To Next Page
Loading...
