Caution
The lane assist system properly works only when the lane boundary is clearly visible. In
some cases, it may not operate normally nor work. For example:
〉
The lane boundary may not be recognized clearly. Or it is a non-standard or covered
lane boundary.
〉
There are objects on the road that affect the identification of lane boundaries (e.g. wa-
ter, creaks, ruts, signs, crosswalks, bump and bit etc.).
〉
Low visibility (such as rain, snow, fog and night etc.).
〉
The vehicle is strongly affected by the side wind.
〉
The lanes merge or separate.
〉
A strong light hits the camera or the light intensity changes abruptly.
〉
The front windshield around the camera is polluted, frozen, damaged or covered.
〉
When the vehicle is driving on a sharp turn, narrow road;
〉
If the vehicle is driving too close to the preceding vehicle, the camera detection scope
is hindered.
Notice
If you turn on the turn signal lamp, turn the steering wheel, operate the accelerator pedal
or brake pedal before passing through a lane boundary, the system will not send an
alarm. In this case, the system thinks you are taking the initiate to drive the vehicle.
Notice
When the driver controls the steering wheel with a small force, the system may not detect
the driver's hand holding the steering wheel, and the combination instrument will send an
alarm message.
Lane assist system
When the lane assist function is turned on, the assist type can be selected.
〉
Warning assist: Can warn the driver to drive safely when the driver is unaware of lane
deviation.
〉
Lane keeping assist: Can assist the driver to correct the steering wheel to keep the ve-
hicle in the lane when the driver is unaware of lane deviation. If the correction fails, it
will give out alarm in order to alert the driver to drive safely.
134
2
Driving
To Next Page
Loading...
