After the speed limit sign is recognized, in case of overspeed, the system will give an
alarm to remind the driver to reduce the speed to a suitable range as soon as possible.
Speed alarm sensitivity
The alarm timing for overspeed can be set according to your driving habits.
〉
0: Alarm will be issued when the vehicle speed reaches the speed limit.
〉
＞ 0: Alarm will be issued only when the vehicle speed exceeds the speed limit.
〉
＜ 0: Alarm will be issued in advance when the vehicle speed does not reach the speed
limit.
Warning
The traffic sign information function is designed to alert the driver to traffic signs and is
not intended to be used in all cases and is not a substitute for the driver's judgment on
road speed limit messages.
In all cases, the driver is responsible for the safety of the vehicle and must always drive
with care and comply with applicable laws and road traffic regulations.
Caution
Traffic sign information function works only when the speed sign is clearly visible. In some
cases, it may not operate normally nor work. For example,
〉
A sign fades.
〉
A sign is on the bend.
〉
A sign is placed with an improper angle.
〉
A flag is rotating or has been damaged.
〉
A sign is fully or partially blocked.
〉
A sign is fully or partially covered by frost, snow, dust, etc.
〉
A high-speed sign is placed in the position that is too far or too high.
〉
A speed limit caution or sign is attached to the road surface.
〉
Visibility is low (such as in rainy, snowy and smog days or at night).
〉
The camera is illuminated by strong light or the illumination intensity changes suddenly.
〉
The front windshield around the camera is polluted, damaged or covered.
〉
The vehicle is running closely to the front vehicle, thus blocking the detection range of
the camera.
〉
The vehicle speed is too low.
140
2
Driving
To Next Page
Loading...
