tire. This helps to seal the puncture
hole.
2. Shake the tire repair liquid and use it
evenly. Make sure that the inflater
switch is off (in position "0"), and then
take out the power cord and inflation
tube.
3. Unscrew the cover of the tire repair flu-
id inlet, connect the inflation tube to the
tire repair fluid inlet and tighten it, and
connect the outlet tube of the tire repair
fluid to the tire valve.
Caution
The inflation tube cannot be bent.
4. Plug the inflater power cord into the
12V power outlet and start the vehicle.
5. Switch the inflater switch to the posi-
tion "I" to start the inflater and inflate
the tire to 240~250 kPa.
Warning
Do not stand beside the tire when operat-
ing the inflater. If the tire is cracked or un-
even, the inflater must be turned off imme-
diately.
Caution
〉
When the inflater is turned on, the air
pressure will be very high at first, then
decrease slowly, and gradually increase
with the inflation air pressure.
〉
The inflater shall not run for more than
10 minutes; otherwise, there is a risk of
overheating.
〉
If the tire pressure is still lower than 170
kPa after inflation, it means that the tire
has a large hole, so please do not con-
tinue to inflate it. At this time, you are
suggested to contact service provider.
6. Turn off the inflater, remove the power
cord from the 12V outlet, and remove
the tire repair fluid from the tire valve.
7. Drive immediately (within 1 minute) at
a speed of 20~60 km/h for about 5 km,
so that the tire repair fluid can seal the
tire evenly.
8. Connect the inflater and read the tire
pressure on the pressure gauge.
〉
If the tire pressure is lower than 170
kPa, it means that the tire is not com-
pletely sealed. At this time, do not
continue driving and contact service
provider.
〉
If the tire pressure exceeds 170 kPa,
the tire shall be inflated to the pres-
sure specified in the tire pressure la-
bel.
9. Turn off the inflater, disconnect the in-
flation tube and the power cord, and in-
stall the dust cover of the tire valve.
Caution
After the tire is inflated, it is necessary to
install the dust cover of the tire valve to
prevent the gravel and dust from damag-
ing the tire valve.
Warning
After the tire is repaired with inflater and
210
5
Emergency
To Next Page
Loading...
