GigE Area Scan Camera User Manual
iv
instructions.
●
The device should be used in an environment that meets the design specifications,
otherwise it may cause malfunctions, and malfunctions or component damage caused
by non-compliance with relevant regulations are not within the scope of the device's
quality assurance.
●
Our company will not bear any legal responsibility for personal safety accidents and
property losses caused by abnormal operation of the device.
Caution:
●
Do not install the device if it is found that the device and accessories are damaged,
rusted, water ingress, model mismatch, missing parts, etc., when unpacking.
●
Avoid storage and transportation in places such as water splashing and rain, direct
sunlight, strong electric fields, strong magnetic fields, and strong vibrations.
●
Avoid dropping, smashing or vigorously vibrating the device and its components.
●
It is forbidden to install the indoor device in an environment where it may be exposed to
water or other liquids. If the device is damp, it may cause fire and electric shock hazard.
●
Place the device in a place out of direct sunlight and ventilation, away from heat sources
such as heaters and radiators.
●
In the use of the device, you must be in strict compliance with the electrical safety
regulations of the nation and region.
●
Use the power adapter provided by the official manufacturer. The power adapter must
meet the Limited Power Source (LPS) requirements. For specific requirements, please
refer to the device’s technical specifications.
●
The plug or socket of the device is a component for disconnecting the power supply,
and do not block it.
●
Make sure to disconnect the power supply when wiring, installing, disconnecting, etc. Do
not operate with electricity, otherwise there will be a danger of electric shock.
●
If the device emits smoke, odor or noise, please turn off the power and unplug the power
cord immediately, and contact the dealer or service center in time.
●
It is strictly forbidden to touch any terminal of the device when operating it. Otherwise
there is a danger of electric shock.
●
It is strictly forbidden for non-professional technicians to detect signals during device
operation, otherwise it may cause personal injury or device damage.
●
It is strictly forbidden to maintain the device is powered on, otherwise there is a danger
of electric shock.
●
Avoid aiming the lens at strong light (such as lighting, sunlight, or laser beams, etc.),
otherwise the image sensor will be damaged.
●
If it is necessary to clean the device, use a damp paper towel or a soft clean cloth to
moisten a little pure water, gently wipe off the dust, and do not use alcohol-based
corrosive solutions. Make sure to power off the device and unplug the power socket
when cleaning.
●
Keep clean of the device’s image acquisition window. It is recommended to use cleaning
water to wipe off the dust.
●
If the device does not work properly, please contact your dealer or the nearest service
To Next Page
Loading...
