GigE Area Scan Camera User Manual
v
center. Never attempt to disassemble the device yourself (we shall not assume any
responsibility for problems caused by unauthorized repair or maintenance).
●
Please dispose of the device in strict accordance with the relevant national or regional
regulations and standards to avoid environmental pollution and property damage.
Note:
●
Check whether the device’s package is in good condition, whether there is damage,
intrusion, moisture, deformation, etc. before unpacking.
●
Check the surface of the device and accessories for damage, rust, bumps, etc. when
unpacking.
●
Check whether the quantity and information of the device and accessories are complete
after unpacking.
●
Store and transport the device according to the storage and transport conditions of the
device, and the storage temperature and humidity should meet the requirements.
●
It is strictly prohibited to transport the device in combination with items that may affect
or damage the device.
●
Please read the manual and safety instructions carefully before installing the device.
●
Please install the device strictly according to the installation method in this manual.
●
The case of the device may be overheated, and it needs to be powered off for half an
hour before it can be touched.
●
The device should not be placed with exposed flame sources, such as lighted candles.
Personnel Requirement
Quality requirements for installation and maintenance personnel: Qualification certificate
or working experience in weak current system installation and maintenance, and relevant
working experience and qualifications. Besides, the personnel must possess the following
knowledge and operation skills:
●
The basic knowledge and operation skills of low voltage wiring and low voltage
electronic circuit connection.
●
The ability to comprehend the contents of this manual.
Electromagnetic Interference Prevention
●
Make sure that the shielding layer of cables is intact and 360° connected to the metal
connector when using shielded cables.
●
Do not route the device together with other equipment (especially servo motors,
high-power devices, etc.), and control the distance between cables to more than 10 cm.
Make sure to shield the cables if unavoidable.
●
The control cable of the device and the power cable of the industrial light source must
be wired separately to avoid bundled wiring.
●
The power cable, data cable, signal cable, etc. of the device must be wired separately.
Make sure to ground them if the wiring groove is used to separate the wiring and the
wiring groove is metal.
●
During the wiring process, evaluate the wiring space reasonably, and do not pull the
cables hard, so as not to damage the electrical performance of the cables.
●
If the device is powered on and off frequently, it is necessary to strengthen the voltage
To Next Page
Loading...
