Network Video Recorder User Manual
99
Figure 8-5 Array List
8.2.3 Manually Rebuild an Array
Purpose
If no hot spare disks are configured, rebuild a degraded array manually.
Before You Start
At least one available physical disk must exist to rebuild an array.
Step 1 Go to Storage > RAID Setup > Array.
Figure 8-6 Array List
Step 2 Click of the degraded array.
Figure 8-7 Rebuild Array
Step 3 Select the available physical disk.
Step 4 Click OK.
Step 5 Click OK on the pop up message box “Do not unplug the physical disk when it is under rebuilding.”
To Next Page
Loading...
