Network Video Recorder User Manual
164
Figure 15-10 SNMP Settings
Step 2 Check Enable. A message will pop up to notify about a possible security risk. Click Yes to continue.
Step 3 Configure the SNMP settings as needed.
Trap Address: SNMP host IP address.
Trap Port: Port of the SNMP host.
Step 4 Click Apply.
15.7 Configure Email
Purpose
The system can be configured to send an e-mail notification to all designated users when a
specified event occurs such as when an alarm or motion event is detected, the administrator
password is changed, etc.
Before You Start
The device must be connected to a local area network (LAN) that contains an SMTP mail server.
The network must also be connected to either an intranet or the Internet depending on the
location of the e-mail accounts to which you want to send notifications.
Step 1 Go to System > Network > Advanced > Email.
To Next Page
Loading...
Need help?
General
