HIKVISION DS-7732NI-I4/24P - 12.11 Defocus Detection

Network Video Recorder User Manual
145
Figure 12-10 Sudden Scene Change
Step 3 Select a camera to configure.
Step 4 Check Enable Sudden Scene Change Detection.
Step 5 Optionally, check Save VCA Picture to save the captured sudden scene change detection pictures.
Step 6 Drag the Sensitivity slider to set the detection sensitivity. Sensitivity range: [1-100]. The higher the
value, the more easily the change of scene can trigger the alarm.
Step 7 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 8 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 9 Click Apply.
12.11 Defocus Detection
Purpose
Image blur caused by lens defocus can be detected.
Step 1 Go to System > Event > Smart Event.
Step 2 Click Defocus.