Hioki RM3542 - Page 127

9.6 Message List
121
9
Message Data Contents Description
Ref
page
Range-Specific Low Power Resistance Measurement Settings
:LPResistance:DELay2
<Range>,<Delay 2 time>
Sets and queries Delay 2. 144
:LPResistance:DELay2?
<Range>
[0 to 0.100]
:LPResistance:NPLCycles
<Range>,<Speed>,
<integration time (NPLC)>
Sets and queries integration time (no.
of power line cycles).
144
:LPResistance:NPLCycles?
<Range>,<Speed> [0.01
to 6]
:LPResistance:APERture
<Range>,<Speed>,
<<integration time (s)>
Sets and queries integration time (in
seconds).
145
:LPResistance:APERture?
<Range>,<Speed>
[0.0001 to 0.1]
:LPResistance:CIMProve
<Range>,<OFF/ HOLD/
PULSe>
Sets and queries Contact Improver op-
erating mode.
145
:LPResistance:CIMProve?
<Range>
[OFF/ HOLD/ PULSE]
:LPResistance:CIMProve:LEVel
<Range>,<Level>
Sets and queries Contact Improver
level.
145
:LPResistance:CIMProve:LEVel?
<Range>
[L1/ L2/ L3/ L4]
:LPResistance:CURRent
<Range>,<PULSe/ CON-
Tinuous>
Sets and queries measurement cur-
rent mode.
146
:LPResistance:CURRent?
<Range>
[PULSE/ CONTINUOUS]
:LPResistance:CONTactcheck
<Range>,<1/ 0/ ON/ OFF>
Sets and queries contact check opera-
tion.
146
:LPResistance:CONTactcheck?
<Range>
[ON/ OFF]
:LPResistance:CONTactcheck:LEVel
<Range>,<Level>
Sets and queries contact check
threshold.
147
:LPResistance:CONTactcheck:LEV-
el?
<Range>
[L1/ L2/ L3/ L4/ L5/ L6/ L7]
:LPResistance:VMONitor
<Range>,<1/ 0/ ON/ OFF>
Sets and queries voltage level monitor
level.
147
:LPResistance:VMONitor?
<Range>
[ON/ OFF]
:LPResistance:VMONitor:LEVel
<Range>,<Level>
Sets and queries voltage level monitor
level.
147
:LPResistance:VMONitor:LEVel?
<Range>
[L1/ L2/ L3]
Notes:
• < >: contents of the data portion.
• [ ]: Response data
• <Range>
For
:RESistance commands: RNG100MIL/ RNG1000MIL/ RNG10/ RNG100/ RNG1000/ RNG10K/ RNG100K/
RNG1000K/ RNG10MEG/ RNG100MEG
For
:LPResistance commands: RNG1000MIL/ RNG10/ RNG100/ RNG1000