11. Rebuild starts up. Drive Management window appears after Rebuild is
complete.
12. Check the progress of Rebuild. Finish LSI Software RAID Configuration
Utility referring to Ending the utility on page 6-15. Then, restart the OS
and check the progress of Rebuild with the RAID utility.
Note:
• See the MegaRAID Storage Manager Version xxx Instruction Manual in
flash memory embedded in the chassis and contained in Driver & Utility
CD respectively for how to find the progress of Rebuild with RAID utility.
See the Hitachi Compute Blade Series Hitachi Compute Rack Series OS
Installation Guide for Windows Server
or Hitachi Compute Blade 500
Series OS Installation Guide for Red Hat Enterprise Linux in the flash
memory embedded in the server chassis for where they are.
• It takes hours for Rebuild to be completed with LSI Software RAID
Configuration Utility. It is recommended that you continue Rebuild on the
OS after ending LSI Software RAID Configuration Utility.
• See
To check on the progress of Rebuild: on page 6-46 for the progress
of Rebuild with LSI Software RAID Configuration Utility.
• See To stop Rebuild: on page 6-48 for stopping Rebuild with LSI
Software RAID Configuration Utility.
•
See
To re-execute Rebuild: on page 6-51 for re-executing Rebuild with
LSI Software RAID Configuration Utility.
To check on the progress of Rebuild:
When checking on the progress of Rebuild with LSI Software RAID
Configuration Utility, follow the steps shown below.
1. Execute step 1, step 4, and step 5 shown in Rebuilding virtual drives on
page 6-43 to show Select Drive Operations window. Then, select Select
Drive
and press Enter.
6-46
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
