Honeywell HC900 - Analog Input;Digital Input;Digital Output;Analog Output

217 HC900 Process & Safety Controller User and Installation Manual Revision 6
21 April 2017
Appendix - Installation of Remote Termination Panels (RTPs)
Overview
The Remote Termination Panel (RTP) provides an easy way to connect the HC900 controller to the field
wiring. The RTP integrates some of the typical externally connected components, reducing wiring and
setup time. It also minimizes the need for multiple wires under a single screw connection by expanding the
connectivity of the shared terminals of the I/O modules.
There are three RTP types: See page
 8 ` Analog Input 218
 Relay Output 225
 16 point Analog Input/Digital Input/Digital Output/Analog Output 229
Figure 96 – Example installation (not shown: 2
nd
RTP & cable for high capacity AI/DI/DO)