Honeywell Vibrex 2000 User Manual

Quick Reference Guide
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
xii
 Observe displayed note then press START.
 Implement the solution and power off the Vibrex unit.
Propeller Balance, After Run No. 1
 Turn on the Vibrex unit.
 Select Propeller Balance from the Main Menu
screen.
 Vibrex 2000 Plus Only - Select Continue Current
Session.
 Edit the solution if it is different from the solution done
earlier then press START.
 Operate the propeller at the same RPM as done in Run No.
1. When the RPM is steady, press START.
 When the Vibrex unit has finished collecting data, press
START.
 Continue making adjustments until the propeller yields the
desired IPS level, then press DONE from the Prop Balance
Quality screen.
Helicopter/Fixed Wing Balance
(EV2K+ only)
First Time Startup
 Install the photocell, velocimeter(s), and reflective tape on
the helicopter/aircraft.
 Turn on the Vibrex unit.
 Select Helicopter Balance from the Main Menu
screen. (Fixed Wing Balance for fixed wing version.)
 Use the ↑↓ ARROW keys to select your user
helicopter/aircraft model from the factory selections.

Honeywell Vibrex 2000 Specifications

General

Brand	Honeywell
Model	Vibrex 2000
Category	Test Equipment
Language	English