Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
139
CAUTION: The track data is displayed numbered from left
to right, top to bottom in passing order. This may be
different from other instruments such as the 8500C and
VXP. Passing order is the first blade to enter the FasTrak
®
camera view once the mag pickup has fired and continues
in the order that the blades pass the track head. This order
may be different from the blade names assigned in
manufacturer’s manuals. If in doubt, it is recommended
that a table is created to map manufacture’s blade names
to EV2K+ passing order numbers.
Use the REF BLADE key to change the reference blade.
The referenced blade will be displayed as 0.0. Mean can
be selected to reference the blades to the average track
height. Absolute can be selected to display the absolute
distance from the tracker head to the blade.
Track height units can be changed by pressing soft key 2
next to the first blade measurement.
Use the LEAD-LAG key to change to toggle between
displaying height and lead-lag data.
► REF BLADE <Mean>
TRACK HEIGHT (IN)
► 1: 0.00 2: -0.50
3: 0.50 4: 0.00
QUAL:38-40
► LEAD-LAG MEAS
to solve, push START
To Next Page
Loading...
Need help?
General
