Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
167
4. This screen allows you to edit the settings for the balance
component. This may be useful if a particular adjustment
point already has an adjustment applied, for example weight
already added or tab already bent. By default, the solution
algorithm will respect the manufacturer’s limits and not give
solutions over these limits.
5. Note: Generally the default settings can be used in most
cases. when implementing a solution, if a limit is exceeded,
the current settings can be edited and a new solution
calculated that respects these limits. This can be done
using ALTERNATE SOLUTION as described below.
BOOKKEEPING <OFF/ON> controls whether changes
are accumulated at the end of a run when you choose
NEXT RUN (MADE). If bookkeeping is ON, the
suggested solutions will not exceed manufacturer’s
limits unless this option is overridden in the
ALTERNATE SOLUTIONS menu. Bookkeeping OFF
functions as if you pressed RESET ALL SETTINGS each
time this menu is entered.
Press EDIT SETTINGS to edit the settings.
Note: A warning screen will warn if a value is entered
that exceeds manufacturer’s limits. This is only a
warning – the edited value will still be accepted.
A-109EPower Run 1
► BOOKKEEPING: <OFF>
► EDIT SETTINGS
for MR Side Trkr
► RESET ALL SETTINGS
if ok, push START
To Next Page
Loading...
Need help?
General
