Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
168
Press RESET ALL SETTINGS to reset settings to their
defaults.
Press the START key to initiate the measurement
collection sequence.
6. A screen will show the desired flight regime, measurement
direction, channel number and desired RPM. Ensure that the
measurement information is correct. Use the GO BACK key
to change the selections if they are incorrect.
Be sure the actual RPM is within several percent of the
desired RPM shown on the screen. This is especially
critical for some ground idle regimes and tail rotors.
Press the START key to initiate the actual measurement.
A progress screen will be shown in step 6.
The ENTER MEAS MANUALLY gives the unique ability
to manually enter a measurement. You can enter any
measurement or recall the previous measurement using
the RECALL PREV MEAS context key.
? ENTER MEASUREMENT
► [00.00] IPS
at
► [12:00] CLOCK ANGLE
► RECALL PREV MEAS
if OK, push START
To Next Page
Loading...
Need help?
General
