HP 3000 9x9KS - Major Code Category E; Major Code Category F

4-24 Display Codes
Major Code Category E
Major Code Category F
D600 Shutdown in progress, busy-wait after update () has completed
D900 Shutdown completed, disks not fully synchronized
D904 TOC dump completed, disks not synchronized)
D910 HPMC completed, disks not synchronized
DA00 Shutdown completed, disks fully synchronized
Table 4-23. MPE/iX System Shutdown Codes
Code Description
D100 Shutdown job sessions
D200 Shutdown error encountered
D300 Shutdown system processes
D400 Shutdown system managers
D500 Shutdown terminating
DA00 Shutdown complete
Table 4-24. MPE/iX Warning Codes
Code Description
Ex40 Power warning
EA10 Mid-temperature warning
EA20 Low-temperature warning
EE80 Monitor, wait for remote power
EE81 Monitor, remote power up
Table 4-25. HP-UX and MPE/iX Run Code
Code Description
FxnF
(HP-UX)
Indicates the system is running. An F in the first and fourth digits indicates the system is run-
ning normally. The x is updated every 5 seconds with the length of the run queue at that time
(an instantaneous reading not an average). It indicates the number of processes. Loads higher
than 9 display as A. The n indicates the number of processors (1, 2, 3,or 4).
FxFF
(MPE/iX)
Indicates the system is running. An F in the first, third, and fourth digits indicates the system is
running normally.the x is an approximate percentage of process activity (times ten).
Table 4-22. HP-UX System Shutdown Codes
Code Description