7-40 Removal and Replacement
HP-PB I/O Card Cage Removal
Refer to Figure 7-32 while performing these steps:
1. Make sure that power has been disconnected from the cabinet and the power switch is in the OFF
position.
2. From the rear of the cabinet, detach any cables connected to cards in the HP-PB I/O card cage.
3. From the rear of the cabinet, remove the connector plug.
Figure 7-32 Removing the HP-PB I/O Card Cage
4. Remove the four screws (two front and two rear) holding the HP-PB I/O card cage in place.
5. From the front of the cabinet, push the card cage (item 1 in Figure 7-32) toward the rear of the
cabinet. Then pull the card cage out from the back of the cabinet along its rails.
WARNING
Hazardous voltages are present even with the power switch in the OFF position. Verify that the
SPU cabinet is disconnected from the AC power source.
To Next Page
Loading...
