4-8 Display Codes
Major Code Category 3
Table 4-6. Processor Dependent Hardware (PDH) Codes
Ostat Code
Description
(Where x = Processor Memory bus slot number)
Descriptions preceded by an asterisk are applicable only for the
following systems: HP 9000 K250/K260/K450/K460/Kx70, HP
VISUAL-IZE K260-EG/K460-EG/K460-XP, and HP 3000 979KS.
TEST 3x00 Start checksuming the FEPROM
TEST 3x01 Testing PDH control register
TEST 3x02 Scratch RAM under test
TEST 3xBC Test system clock setup
TEST 3xCD Checking Stable Storage validity
INIT 3x00 FEPROM checksum correct
INIT 3x01 Initialize the PDH control register
INIT 3x02 Scratch RAM successfully initialized
INIT 3x07 Entering LDB
INIT 3xBC Finished testing system clock
INIT 30C4 Clearing and revalidating EEPROM
INIT 3xCD Initializing Stable Storage
WARN 3x03 Error reading stable storage, contents are invalid
WARN 3x04 Error writing to the EEPROM
WARN 3x06 Error reading EEPROM
WARN 3x1A System Hversion in stable storage does not match the hardware
WARN 3x2A Calculation of HVERSION failed for CPU x
WARN 3xBC Skipped system clock test
FLT 3x00 FEPROM checksum failure
FLT 3x01 PDH control register failure
FLT 3x02 Fatal fault in scratch RAM
FLT 3x03 Fault reading stable storage and no console present
FLT 3x04 Fatal fault writing to the EEPROM
FLT 3x05 Write limit exceeded
FLT 3x06 Fatal fault reading EEPROM
FLT 3xCC *PDH cache size bad
FLT 3xCD Fatal error initializing Stable Storage
FLT 3x08 Invalid system board byte
FLT 3x09 Invalid system mode byte
FLT 3x0A Invalid system MFG test byte
FLT 3xBC Invalid system clock setup (CPU clock speed mismatch)
FLT 30F4 Number of boots exceeded 95,000
To Next Page
Loading...
