Install and Configuration 2-21
MPE/iX Remote Access
To have remote access for the HP 3000 computer you must configure Logical Device 21 in the operating
system and on the core I/O card.
Logical Device 21 System Configuration
To establish a dial-in session for remote access through the internal modem, logical device 21 has to be
configured in the operating system. To check the logical device 21, perform the following steps:
1. At the
MPE/iX prompt, type
SYSGEN
.
2. At the
SYSGEN> prompt, type
IO
. This puts you into the I/O submenu of SYSGEN.
3. AT the
IO> prompt, type
lpath 10/4/0.1
. The lpath (list path) command will display the configured
parameters for path address 10/4/0.1, as shown:
4. If the information is incorrect, delete device 21 by typing
io> DD 21
, before adding the correct
information.
5. If there is no information displayed for the path 10/4/0.1 (logical device 21), then add the necessary
configuration information with the AD 21 command, as shown:
6. In the I/O submenu of SYSGEN, do a list device 21 (LD 21) and ensure that the following
information is shown:
NOTE
The following procedures are only applicable if HP Predictive has not been installed. If HP predic-
tive is installed, use Predictive to configure the internal modem for remote access. Refer to the Pre-
dictive Support User’s Guide (part number 50779-90018).
PATH: 10/4/0.1 LDEV: 21
ID: A2372-60003-CONSOLE-TERMINAL TYPE: TERM
PMGR: CDM_CONSOLE_DM PMGRPRI: 9
LMGR: TIO_TLDM MAXIOS: 0
io> AD 21 ID=A2372-60003-CONSOLE-TERMINAL; PATH=10/4/0.1
LDEV: 21 DEVNAME: OUTDEV: 21 MODE: JAID
ID: A2372-60003-CONSOLE-TERMINAL RSIZE: 40 DEVTYPE: TERM
PATH: 10/4/0.1 MPETYPE: 16 MPESUBTYPE: 0
CLASS: TERM
To Next Page
Loading...
