7-28 Removal and Replacement
Power Supply (all models except HP3000/979KS, HP9000/K250/K260/
K450/460 and HP VISUALIZE Workstation models)
Removal: Refer to Figure 7-23
1. Disconnect the power cord (1).
2. loosen the four (two top and two bottom) captive mounting screws (2).
3. Pull the extractor levers (3) out to disengage the power supply from the chassis.
4. Grasp the handle (4) on the power supply bulkhead and pull the power supply out of the chassis.
Figure 7-23 1250 VA Power Supply Removal
Replacement:
1. Align the power supply in the chassis.
2. Push the power supply into the chassis very firmly to fully seat it into the system card.
3. Tighten the four mounting screws.
4. Plug the power cord into the power supply receptacle.
To Next Page
Loading...
