SCSI and I/O 8-113
positioned as shown, according to the desired address. The parity jumper should always be installed.
Preventative Maintenance
There is no preventative maintenance required for this product.
Troubleshooting
This product is considered a single FRU and is replaced as a complete assembly.
Drive Status Light
1. After Drawer is closed:
Light OFF after short blinking sequence = Drive Ready or Stand-by.
Light ON = No disk present.
Light Blinking at 3.2 second interval = Cleaning of disk or optics required.
2. While Playing an Audio Track:
Light Blinking at 1.6 second interval
3. When Accessing Data:
Light Blinking at 0.2 second interval.
Internal Drive Logs
Available from interactive section of diagnostic.
Replacement Part Number
The exchange part number is: A1658-60018
Diagnostics
CSTM
SCSICD
IOMAP
SYSMAP
.
Note
Do not use SCSI ID 7, that address is reserved for the host.
To Next Page
Loading...
