Display Codes 4-11
Major Code Category 7
Table 4-9. Processor/Memory Bus (Bus 0) Slot Identification
MID # Description
0 Processor (CPU) slot 0
1 Processor (CPU) slot 1
2 Processor (CPU) slot 2
3 Processor (CPU) slot 3
4 IOA0 (system board)
5 IOA1(system board)
6 IOA2 (Dual Bus 4-slot HSC Expansion I/O) or CPU Slot 4
7 IOA3 (Dual Bus 4-slot HSC Expansion I/O) or CPU Slot 5
Table 4-10. Memory Subsystem Codes
Ostat Code Description
FLT 7000 HPMC in the memory system
FLT 7001 Icache parity fault in memory test
FLT 7002 Dcache parity fault in memory test
FLT 7003 MSI read time-out (usually caused by reading beyond the end of memory)
FLT 7004 MSI write time-out (usually caused by writing beyond the end of memory)
FLT 7005 Processor/Memory bus parity fault
FLT 7006 Write bomb fault (Processor/Memory bus parity detected on incoming data)
FLT 7007 Memory address ECC fault
FLT 7008 Multi-bit memory fault
FLT 7009 Single bit memory fault
FLT 70FF Unknown HPMC
FLT 7FFF Catastrophic memory fault
FLT 7101 Master Memory Controller not responding
FLT 7102 Master Memory Controller not ready fault
FLT 7103 Master Memory Controller failed to clear
FLT 7104 Master Memory Controller sticky bits
FLT 7105 Master Memory Controller bad revision
FLT 7106 Master Memory Controller register selftest fault
FLT 7107 Master Memory Controller fault in ECC test
FLT 7200 No Slave Memory Controller available
FLT 721x Slave Memory Controller failed, x = SMC 0-3 on memory carrier 0
x = SMC 4-7 on memory carrier 1
To Next Page
Loading...
