4-12 Display Codes
FLT 722x Bad Slave Memory Controller revision, x = SMC 0-3 on memory carrier 0
x = SMC 4-7 on memory carrier 1
FLT 7230 Slave Memory Controller failed to respond
FLT 7301 SIMM 0 bytes are not equal
FLT 7302 SIMM 1 bytes are not equal
FLT 7303 SIMM 0 data <> SIMM 1 data
FLT 7304 Unknown sizing compare fault
FLT 7305 Multi-bit error occurred during sizing
FLT 7306 Address test failed on bank
FLT 7307 ECC test failed on bank
FLT 7308 Single bit memory error caused HPMC
FLT 7401 No memory SIMMs installed
FLT 7402 Both EDO and STD memory SIMMs installed
FLT 7403 Address did not map to bank
FLT 7404 Address did not map to Group Configuration Table
FLT 7405 Dual issue test failed
FLT 7500 No RAM found
FLT 7501 Not enough good memory to run Operating System
FLT 7502 Not enough good memory to run Boot Console Handler
FLT 7604 No bits set in memory test status
FLT 7Fxy x=SMC#, y=SIMM pair
WARN 7701 Using alternate memory configuration
WARN 7702 Memory not tested, initialized only
WARN 7703 SIMM loading warning
WARN 7704 RAM bus warning
WARN 7705 Good memory required to run Operating System is greater than memory size
WARN 7706 Both EDO and Standard DRAMs in system.
WARN 770F Rev 1 Slave Memory Controller installed
TEST C210 Memory hard reset
TEST C220 Physical configuring memory
TEST C230 Sizing memory banks
TEST C240 Loading memory configuration from EEPROM
TEST C250 Configuring memory interleave
TEST C260 Testing memory interleave
TEST C261 Testing first page of memory
TEST C262 Testing dual issue
TEST C263 Testing memory, write test
TEST C264 Testing memory, read/write test
Table 4-10. Memory Subsystem Codes (Continued)
Ostat Code Description
To Next Page
Loading...
