7-52 Removal and Replacement
Magnetic Door Catch Replacement:
1. Align the magnetic door catch back to the mounting hole in the rear door.
2. Firmly press the door catch into the rear door mounting hole.
3. Press the door catch until the mounting tabs snap into place and the door catch is firmly locked into
place.
4. If the door catch plate needs to be replaced, peel the adhesive cover off the back of the catch plate.
Then align it with the magnetic door catch and press it against the side cover until firmly stuck.
Door Bumper
The rear door bumpers (one top and one bottom) are self-adhesive rubber bumpers stuck to the rear door.
To remove, pry the bumper off with a flat blade screwdriver. To put a bumper on, peel off the adhesive
cover, and press the bumper on the appropriate corner of the rear door.
To Next Page
Loading...
