7-18 Removal and Replacement
Core I/O Card
Refer to the special note regarding extractor brackets on the page following.
Removal: For K2xx/K4xx/9x9KS systems, refer to Figure 7-14 For Kx70 systems, refer to Figure 7-5.
1. Disconnect all cables from the Core I/O bulkhead.
2. Loosen the two (one top and one bottom) captive mounting screws (1).
3. Pull the extractor levers (2) out, pull the core I/O card out of the chassis by the extractor levers.
Figure 7-14 Core I/O Removal
(For HP9000/Kx70 slot locations, see Figure 7-5)
Replacement:
Be sure to move the card in the Optional I/O slot if a different Core I/O card is being installed in the
computer.
1. Align the core I/O card in the appropriate slot.
2. Insert the core I/O card into the chassis until it contacts the system card and the extractor levers engage
the chassis tabs.
3. Push extractor levers down to fully seat the core I/O card into the system card. The levers should be
parallel with the rear bezels.
4. Reconnect all cables that were removed.
To Next Page
Loading...
