SCSI and I/O 8-71
HP A3183A DDS-2 Tape Drive
Figure 8-37 shows the front of an HP A3183A DDS-2 tape drive.
Figure 8-37. HP A3183A DDS-2 Tape Drive
Specifications
• Integrated Single-ended SCSI-2 interface
• Reads and Writes DDS-1 and DDS-2 formats dependent on the mounted tape dimension.
60 meter tape - DDS-1 = 1.3 Gbytes
90 meter tape - DDS-1 = 2.0 Gbytes
120 meter tape - DDS-2 = 4.0 Gbytes
With Data Compression enabled, the above capacities will increase from 2 to 4 times the non
compressed capacities. The average data compression factor is 2 to 1.
• 1 Mbyte Data Buffer
• Switch or program selectable on-board DCLZ data compression
• Automatic Error correction and detection
• Downloadable firmware
• Asynchronous burst data transfer rate = 3.0 Mbytes/sec.
• Synchronous burst transfer rate maximum = 7.5 Mbytes/sec.
• MTBF = 200,000 power on hours at a 12% duty cycle
• Executes self-test at power on
• Inquiry Vendor Identification String = HP
• Inquiry Product Identification String = C1533A
• Inquiry Product Revision Level String = HPE0
To Next Page
Loading...
