Support Information B-6
Access Port Commands
Access to the Access Port (AP) commands is via the ctrl + B function, with the SPU key switch in the
SERVICE position.
Table B-1. Access Port Commands
Command Description Remarks
CA Configure command for the Access Port Internal/external modem port, system identification, bit
rate, protocol, and:
3000 only - Allows autoanswer to be ON or OFF
9000 only - Allows selection of HP or Non-HP console
CO Enter console mode
CS Copy screen from local to remote con-
sole terminal
DI Disconnect line to remote console termi-
nal
DR Disable access by a remote console ter-
minal
Enable session mode access
DS Disable display of system status line
ER Enable access by a remote console termi-
nal
Disable session mode access
ES Enable display of system status line
HE Display AP commands
LR Lock remote Disable modem access
MS Displays modem status Hit return to stop
RS
*
Reset system, initiates SPU selftest,
stops processing
Starts software load from load device if autoboot enabled.
Does not reset AP
SE Transfers remote terminal from console/
control to session mode
SL Displays last 50 chassis codes
SO Sets the security level Requires a PASSWORD (Call the Response Center for the
password).
TA Initiates ap selftest
TC
*
Transfer of control Retains memory status
TE Sends message between the remote and
local consoles
UR Unlock remote Enable modem access
CAUTION
* These commands RESET the system. Be very careful using them, it could result in lost data and it
will crash all users on the system.
To Next Page
Loading...
