Removal and Replacement 7-9
HP 9000/K100 SIMM Removal
For memory SIMM location identification, refer to the MEMORY INSTALLATION label on the rear cover
plate (or bulkhead). You may also need a flashlight or alternate light source to see inside the cabinet.
1. Remove the rear cover plate by loosening the four captive screws and pulling it away.
2. Carefully reach inside the cabinet and push down on the SIMM extractor lever to un-seat the memory
SIMM.
3. Grasp the SIMM card on the top and bottom edge and pull out of the connector.
HP 9000/K100 SIMM Replacement
1. Carefully align the SIMM card to the appropriate memory connector.
Figure 7-7 HP 9000/K100 Memory SIMM Location
2. Press firmly into place (be sure the extractor lever is up against the SIMM cards).
3. Be sure the SIMM card is fully seated before re-installing the cover plate and turning the SPU on.
HP 3000/939KS/959KS/969KS/979KS and HP 9000/K2x0/K4x0/Kx70 SIMM
Removal
1. Remove the front bezel.
2. Remove the front cover plate (for memory, power monitor, and CPU).
To Next Page
Loading...
