7-12 Removal and Replacement
Internal Peripheral Bay
The peripheral bay can house up to six devices. The top two slots are for removable media (i.e. floppy disks,
CDs, or tape) the bottom four slots are for hard disk devices.
Removal: Refer to Figure 7-10
1. Remove the front bezel.
2. Loosen the four captive mounting screws — two on top (1) and two on bottom (1). (The two in the
middle are for the upper slots).
3. Pull the peripheral bay extractor levers (2) up.
Figure 7-10 Peripheral Bay Removal
4. Pull the peripheral bay out of the chassis by the extractor levers. There are no cables to disconnect to
remove the bay from the chassis.
To Next Page
Loading...
