Removal and Replacement 7-15
4. Loosen the two captive mounting screws (4) and pull the upper tray out of the peripheral bay.
Figure 7-12 Upper Peripheral Removal
5. Remove the eight (four on top and four on bottom) mounting screws holding the device in the upper
tray.
Replacement:
1. Align the device into the upper tray and insert the eight (four on top and four on bottom) mounting
screws.
2. Insert the upper tray into the peripheral bay and push it all the way in. Tighten the two mounting
screws.
3. Connect the SCSI cable and power cable.
4. Mount the peripheral interconnect card on the back of the peripheral bay.
5. Replace the peripheral bay into the chassis.
To Next Page
Loading...
