7-24 Removal and Replacement
Figure 7-19 HSC Expansion I/O Card Disassembly
Replacement:
1. Position the HSC Expansion I/O exchange PCB, component side up, over the alignment pins (see Fig-
ure 7-19).
2. Lower the PCB onto the alignment pins and slide the PCB toward the bulkhead assembly until the
PCB stops against the alignment pins.
3. Insert and tighten the two Phillips head screws, taking care to not strip the screw standoffs.
4. Align the expansion I/O card in the appropriate slot.
5. Insert the expansion I/O card into the chassis until it contacts the system card and the extractor levers
engage the chassis tabs.
6. Push extractor levers down to fully seat the expansion I/O card into the system card. The levers should
be parallel with the rear bezels.
7. Reconnect all cables that were removed.
To Next Page
Loading...
