Install and Configuration 2-5
OSTAT in the above sequence can equal one of the following states:
•OFF
• FLT (fault)
• TEST
• INIT (initialize)
• SHUT (shutdown)
• WARN (warning)
•RUN
• ALL
This sequence is followed by the system prompt. Refer to the System Administrators Manuals for the
appropriate operating system instructions to proceed with the system configuration.
Display Panel Environment Observations
Key switch in Standby.
No power cord.
Blank Display.
SWITCH OFF Key switch in Standby.
Power cord installed.
AC power installed, back light is off. Front panel
displays SWITCH OFF
PROCEEDING TO
TURN DC ON
Key switch is On. Display panel shows message, back light is on 1 to
2 seconds after display starts.
OSTAT XXXX Key switch is On.
PDC is loading.
Ostats and chassis codes are displayed at the panel
and console banner. Chassis codes range from
0000 to CDFF. Refer to Chapter 4.
OSTAT XXXX
CPU XXXX
Key switch is On.
ISL is running.
System initialization codes are being displayed.
OS or Diag loading can be started. Codes range
from CE00 to CEDF. Refer to Chapter 4.
OSTAT XXXX
CPU XXXXX
Key switch is On.
OS load in process.
OS is loading from disk or tape. Codes may range
from CEE0 to CFFF. Refer to Chapter 4. CPU
XXX shows processors installed (0-5).
RUN FXYF
CPU XXXXXX
Key switch is On.
OS load complete.
OS is running.
The OS is finished loading. The X after RUN =
CPU utilization, The Y= number of processors.
CPU XXX shows processors installed (0-5).
To Next Page
Loading...
