Memory Configuration Guidelines C-3
If you get the warning, Memory not optimized, use the me command in the Information Menu of the user
interface (the Boot Console Handler) to check your memory configuration. This command will not directly
tell you whether your memory is installed for optimum performance; it will only tell you whether the
modules are seated correctly and recognized as part of your system configuration. However, you can
review the sequence of memory modules in the memory extenders. The most important memory
optimization rule is that all module pairs of each memory size should be installed in lower-numbered slots
before any modules pairs (see the procedures and examples on pages C-3 through C-11). If the display of
your memory configuration shows any single modules installed before module pairs , you will need to
reconfigure your memory using those procedures.
If the warning Memory not optimized does not appear, your memory is at optimum configuration.
To Next Page
Loading...
