Troubleshooting 3-17
HP-UX Procedure:
1. Reset the system.
2. Stop the autoboot process if it is enabled.
3. From PDC service menu, enter the
PIM command. Record or print the PIM report, specifically
timestamps, chassis codes, responder/requestor addresses, I/O module error log, and memory error
log.
4. Refer to Table 3-12 for description and action for each HPMC chassis code. Table 3-13 identifies the
slot numbers on the Processor/Memory bus.
MPE/iX Procedure:
1. Perform a TOC.
2. From the PDC service menu, enter the
PIM command. Record or print the PIM report, specifically
timestamps, chassis codes, responder/requestor addresses, I/O module error log, and memory error
log.
3. Perform a memory dump (refer to Performing a Memory Dump section).
4. Refer to Table 3-12 for description and action for each HPMC chassis code.
For Major Category 5 (Bus Transactions) Chassis Codes, the Master ID (MID) will identify the CPU or IOA
as follows:
Description SPA
K2x0/K4x0 K370/K380 K570/K580
MID
CPU 0 FFFA0000 0 0 0
CPU 1 FFFA2000 1 1 1
CPU 2 FFFA4000 2 2 2
CPU 3 FFFA6000 3 3 3
CPU 4 FFFAC000 —6 6
CPU 5 FFFAE000 — 7 7
IOA 0 (system board) FFF88000 4 4 4
IOA 1 (system board) FFF8A000 5 5 5
IOA 0 (HSC expansion I/O) FFF8C000 — — 6
IOA 1 (HSC expansion I/O) FFF8E000 — — 7
MMC FFFB1000 7 — —
To Next Page
Loading...
