HP 54620A - To Clear a Previously Saved Trace

To clear a previously saved trace
1
Press
Trace
.
2
Press the
Trace
softkey to choose either
Mem1
or
Mem2
.
Mem1
and
Mem2
correspond to the two pixel memories in which a waveform
might have been saved.
3
Press the
Clear Mem
softkey.
Clear Mem
will be either
Clear Mem1
or
Clear Mem2
, depending on which
memory you selected in Step 2.
The waveform is cleared from the selected trace memory. However, the setup
information is not cleared from that memory. So, if you press
Recall Setup
after pressing
Clear Mem
, the setup in effect at the time that memory was
saved is restored.
Making Analyzer Measurements
To clear a previously saved trace
116