To initialize the label list
1
Press
Label
.
2
Press the
Initialize Label List
softkey.
A message appears, warning you that this operation will overwrite the
current label list.
•
To confirm the operation, press the
Yes
softkey. You will be prompted to
press Yes again to initiate the operation.
•
To cancel the operation, press the
No
softkey.
When you first begin using the analyzer, there are seven blank entries at the
beginning of the label list. As you define custom labels, these spaces are
filled. One blank space is always retained to allow entry of a new label. When
you initialize the label list, all of your custom labels will be cleared.
Making Analyzer Measurements
To initialize the label list
64
To Next Page
Loading...
