HP 54620A - To Remove the Display

To remove the display
1
Remove the front panel on the HP 54620A/C.
2
Disconnect the ribbon cable and the calibration cable from the
display.
3
Using the T10 TORX driver, remove the two screws that hold the
display to the deck.
Make sure that when you re-install these screws that you use the
correct parts. If longer screws are used, they can short the system
board to ground.
4
As you lift the display, rotate it off the two tabs on the side of the
deck.
Replaceable Parts
To remove the display
185