9
Is the fan running?
If yes, go to “To perform self-tests.” If not, do the steps below.
The LVPS has a thermal cut-out circuit. If the fan is defective, the LVPS
shuts down when it gets too hot for safe operation.
a
Disconnect the fan cable from the power supply.
b
Measure the fan voltage at the connector on the power supply, using a
voltmeter.
If the fan voltage is less than –5.0 Vdc, replace the fan. If not, replace
the power supply.
Testing, Adjusting, and Troubleshooting the Analyzer
To troubleshoot the logic analyzer
167
To Next Page
Loading...
