Print canceled
This message appears when you press the Cancel Print softkey to stop
printing.
Printer not responding
You selected Print Screen in the Print/Utility menu, and there is an interface
installed, but the printer is not responding.
•
Check that the printer is turned on and has paper.
•
Check that the interface module for the HP 54620A/C is connected to the
printer and that the correct interface type is being used.
Printing done
This message appears when the analyzer has finished copying the screen to
the printer.
Privilege Violation
A processing fault occurred during operation. Cycle power to the analyzer, or
perform a hard reset by cycling power with one of the softkeys depressed. If
this does not correct the problem, contact your HP Sales Office.
Re-Initializing the Label List . . . .
This message appears briefly while the analyzer is re-initializing the label list.
Screen and setup saved to memory
This message appears when you save the current display and setup using the
Trace memory menu.
Selected channel at bottom of screen
This message appears when you turn the Move knob counterclockwise and
the selected channel is already at the bottom of the display.
Messages
213
To Next Page
Loading...
