Removal and Installation
8-50
HP DesignJets 1050C and 1055CM Printers Service Manual
NOTE For the following steps, refer to Figure 48.
CAUTION The rear bushing (item 1) on the carriage assembly is tensioned
with a spring (item 2). When removing the carriage assembly
(item 3) hold the rear bushing on the carriage assembly.
16. Remove the carriage assembly (item 3) by sliding it off the slider
rods.
17. Remove the belt (item 4) from the carriage assembly by releasing it
from retaining clips (item 5) underneath the carriage assembly.
Figure 48: Carriage Assembly and Belt
1
2
3
5
4
To Next Page
Loading...
