Removal and Installation
8-54
HP DesignJets 1050C and 1055CM Printers Service Manual
3. Remove the following:
1. "Window" see page 8-30.
2. "Top Cover" see page 8-31.
NOTE For the following steps, refer to Figure 54.
4. Loosen the retaining screw T-9 at the back of the printhead tube
connector.
5. Remove the printhead tube connector.
Figure 54: Printhead Tube Connector Removal
6. Remove the tube retaining clip (item 1) from the back of the printer
(refer to Figure 55).
Figure 55: Tube Retaining Clip
a. Push in here
b. Pull here
c. Loosen this screw
View from the rear
Printhead tube connector
a. Push in here
1
To Next Page
Loading...
