DescriptionError
Time-out waiting for radii estimate.74CEh
Radii estimation process failed.74CFh
Recover tape time-out error.74D0h
Invalid cartridge type.74D1h
Cal reel driver offset time-out.74D2h
Time-out waiting for the specified event.74D3h
Front-reel motor hall sensor fault.74D4h
Back-reel motor hall sensor fault.74D5h
The deslacking process timed out and did not complete, probably because the back reel
motor failed to rotate.
74D6h
Threading time out while waiting for half moon to pass the first roller.74D7h
Timed out waiting for tape to reach position for speed-up during a thread.74D8h
Time out while waiting for tape to reach the position to stop threading.74D9h
An unthread command was issued and aborted a tape motion operation that was already
in progress.
74DAh
The cartridge type has not been specified either from LTO-CM or through a serial port com-
mand.
74DBh
The tape speed reported by the DSP is significantly different from the tape speed indicated
by the hall sensors.
74DCh
Specified value of tension is either too high or too low.74DDh
The panic stop process timed out and did not complete properly.74DEh
Timed-out waiting for the proper tape tension to be established.74DFh
Head selection time-out.74E0h
Unable to position the head.74E1h
Speed too low for enabling the heads.74E2h
Speed too low for the head servo.74E3h
Speed too low for sensor calibration.74E4h
A DSP seek command was attempted while the tape speed was zero.74E5h
DSP sensor calibration command was attempted while the tape speed was zero.74E6h
First write fault.7500h
Write fault: it has been too long since a valid LPOS was read, so writing is not allowed.7501h
Write fault: DSP tracking recovery operations are in progress so writing is not allowed.7502h
Drive error codes122
To Next Page
Loading...
