DescriptionError
Write fault: tape motion start-up operations are incomplete so writing is not allowed.7503h
Write fault: DSP is not tracking properly on the tape, writing is not allowed.7504h
Write fault: the current tape speed is too low so writing is not allowed.7505h
Write fault: ATS clock frequency clipped, or DSP in idle mode.7508h
Write fault: DSP calibrating.7509h
Write fault: DSP VI track follow.750Ah
Write fault: DSP tape off-track.750Bh
Write fault: DSP demod channel out.750Ch
Write fault: DSP seek.750Dh
Write fault: DSP uPVI.750Eh
Write fault: write unsafe.750Fh
Unknown write fault.7510h
Multiple write faults.7511h
Last write fault.7512h
Write is not allowed; a power-on or reset occurred.7513h
Write is not allowed; a micro-jog is being applied.7514h
Write fault last.7515h
Set Speed command invalid parameter.7600h
Adjust Speed command invalid parameter.7601h
Set Position command invalid parameter.7602h
Set Head Position command invalid parameter.7603h
Set Head Table command invalid parameter.7604h
DSP Statistics command invalid parameter.7605h
Get Servo Fault command invalid parameter.7606h
Set Tracking Offset command invalid parameter.7607h
Set Notify command invalid parameter.7608h
Clear Notify command null handle.7609h
ATS Diagnostics command invalid parameter.760Ah
Hall Calibrate command invalid parameter.760Bh
Radius Calibrate command invalid parameter.760Ch
Volume 1: hardware integration 123
To Next Page
Loading...
