DescriptionError
Wait Until Event command invalid parameter.760Dh
Convert LPOS command invalid parameter.760Eh
Shuttle command invalid parameter.760Fh
Get DSP fault log invalid parameter.7610h
Set General Command Invalid parameter.7611h
Set TestMode command parameter is out of range or is invalid.7612h
EEPROM servo table command parameter is out of range or is invalid.7613h
Rotate command — invalid parameter.7614h
Measure Kt command — invalid parameter.7615h
Set speed operation timed out during a recover tape command.7620h
Timed out waiting for the pin sensors to indicate almost parked.7621h
Timed out waiting for the pin sensors to indicate fully parked.7622h
An unthread timed out waiting for the full leader pin seating tension to be established.7623h
Cycling the pull-in tension did not achieve pin-park.7624h
Rethreading and then unthreading again did not get the leader pin parked.7625h
Timed out during the rethread/re-unthread recovery while waiting for almost parked.7626h
All recovery algorithms have been exhausted and still unable to park leader pin.7627h
Rethread recovery operation timed out waiting for the tape to come to a stop.7628h
Rethreading timed out while waiting for the tape to reach the required position.7629h
Deslacking process did not complete., probably because the back reel motor failed to rotate.762Ah
The leader pin was parked as indicated by both LP sensors but then came unparked.762Bh
The tape has been recovered and leader pin parked but the original operation failed and
was abandoned.
762Ch
Rethreading timed out while waiting for the tape to reach the required position.762Dh
Rethread recovery operation timed out waiting for the tape to come to a stop.762Eh
A special unthreading recovery operation was needed to un-jam the leader block.762Fh
An iteration of the special unthreading recovery operation did not succeed.7630h
The stop tape operation took longer than expected.7631h
An attempt was made to stop the tape while still too far away from the specified position.7632h
An abort command was issued and stopped the tape motion operation that was already in
progress.
7633h
Drive error codes124
To Next Page
Loading...
