DescriptionError
Unable to detach leader block during recover tape operation when reverse threaded.7650h
Unable to detach leader block during recover tape operation when forward threaded.7651h
Unable to identify cartridge type during recover-tape operation.7652h
The tape thickness reported by the Cartridge Memory is too large or too small.7653h
The tape thickness reported by the CM is invalid and cannot be used.7654h
The full pack radius reported by the CM appears to be invalid and will not be used.7655h
The tape length reported by the CM appears to be invalid and will not be used.7656h
The empty reel inertia reported by the CM appears to be invalid and will not be used.7657h
The empty reel radius reported by the CM appears to be invalid and will not be used.7658h
The front reel is not rotating properly. It is possible that some tape was spilled out from the
back reel.
7659h
Recovery process was unable to determine the best direction in which to move the tape.765Ah
Front reel did not reverse direction after passing through the critical region for threading re-
versal.
765Bh
Back reel did not stop as expected during a tape recovery process.765Ch
Warning: Leader block demate process resorted to pushing the back reel clockwise.765Dh
Rethreading position time-out during the leader block demate retry process.765Eh
Leader block demate retry process was unsuccessful.765Fh
It was necessary to tug the tape to detach the leader block.7660h
Timed out waiting for the required number of layers to overwrap the leader block.7661h
Timed out waiting for the tape to unwrap from the leader block during a reverse thread.7662h
Timed out waiting for a return to the original lock-in position during a reverse thread.7663h
DSP tuning parameters were reloaded into the DSP before a VI-sensor calibration command.
This is a recovery algorithm.
7664h
A special test mode has been enabled that will generate specific faults.7665h
The special test mode has now been disabled. Normal operation will resume.7666h
The front reel is not running in the reverse direction after the tension ramp after passing
through the critical region during a thread.
7667h
The front reel did not reverse direction after passing through the critical region during an
unthread, step 1.
7668h
The front reel did not reverse direction after passing through the critical region during an
unthread, step 2.
7669h
Timed out waiting for speed to reduce while approaching the critical region during a thread.766Ah
Drive error codes126
To Next Page
Loading...
