Table 46 Error codes (part code 5205) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the microcode version of the
storage system.
The operation failed, because the current
microcode version does not support the
capacity of the specified source volume.
780565205
WCheck the microcode version of the
storage system.
The operation failed, because the current
microcode version does not support the
capacity of the specified target volume.
780575205
WCheck the microcode version of the
storage system.
The operation failed, because the current
microcode version does not support the
capacity of the specified reserved
volume.
780585205
Part code 5210
Table 47 Error codes (part code 5210)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
iChange the monitor switch to ON, and
accumulate the data.
There is no monitoring data.50105210
WTo continue processing, click [OK]. To
stop processing, click [Cancel].
The plan will be deleted. Do you want
to continue?
90605210
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
The specified instructions will be reset.
Do you want to continue?
90615210
iClick [Apply] at once.Do you want to cancel the migration
plan(s)?
93195210
iFind error locations. If necessary, retry
the operation.
Some errors occurred. Find on-screen
items that could not be changed.
93575210
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
This migration plan extends across
multiple CLPRs. Do you want to continue
this operation?
590005210
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
This migration plan extends across
multiple SLPRs. If you perform this
operation, the storage partition
administrator will become unable to
operate. Do you want to continue this
operation?
590715210
iCheck the content of the plan in the
application that specifies the migration
plan.
This migration plan is in Suspend status
because an error occurred during
migration.
657135210
WRestore the pool associated to the target
volume, then retry the operation.
This migration plan cannot be executed,
because the pool associated to the target
volume is blocked.
668005210
WIncrease the capacity if the pool is
associated to the target volume, then
retry the operation.
This migration plan cannot be executed
because the usage rate of the pool
associated to the target volume may be
100 percent or more.
668015210
Part code 5210 129
To Next Page
Loading...
Need help?
General