Part code 9010
Table 79 Error codes (part code 9010)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf the same problem persists despite
retrying, please contact HP Technical
Support
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
74409010
WCheck the device emulation type or the
definition of the journal volume.
There are no valid volumes.93039010
WInstall additional license key(s) to expand
the license capacity of this software title.
The maximum permissible capacity of
program product became insufficient.
Please install additional license key(s) to
expand the license capacity of this
software title.
657039010
iPurchase the license when the licensed
capacity runs short.
The used capacity is being calculated
now.
The licensed capacity might be
insufficient by this operation.
790039010
Part code 9105
Table 80 Error codes (part code 9105)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WClick [OK], then install the program
product.
The program product is not installed.55119105
WClick [OK], correct the security group
settings, then retry the operation.
The settings of the security group are
invalid.
56009105
WClick [OK], correct the host group
settings, then retry the operation.
The settings of the host group are invalid.56019105
WClick [OK], correct the length of the letter
string, then retry the operation.
The length of the letter string is invalid.56029105
WClick [OK], specify other hosts, and retry
the operation.
The DKC emulation is specified as the
type of the host.
56039105
WClick [OK], correct the vendor
information, and retry the operation.
The specified vendor information is
invalid.
56049105
WClick [OK], delete unnecessary hosts,
and retry the operation.
You cannot register any more hosts.56059105
WClick [OK], delete the unmounted LDEV,
and retry the operation.
The target LDEV is not mounted.56069105
WClick [OK], correct the LDEV group
settings, and retry the operation.
The settings of the LDEV group are
invalid.
56079105
WClick [OK], check the attributes of the
specified volumes, and retry the
operation.
The pool group cannot include volumes
to which LU paths are defined, or
volumes which are not mounted.
56089105
WClick [OK].
Change the group attribute or delete the
R-VOL/T-VOL from the group.
Retry the operation.
The R-VOL/T-VOL exists in a group which
cannot include R-VOLs and T-VOLs.
56099105
282 Message (part code group 9nnn)
To Next Page
Loading...
Need help?
General